E10
Honiture
Gyroscope / IMU Sensor Error
Robot vacuum announces a navigation error or shows E10; it moves erratically, spins, or cannot map rooms.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Internal gyroscope calibration lost, Strong magnetic or impact damage, IMU connector loose on main PCB, IMU sensor failure
How to Fix / Troubleshooting
Safety first: Turn OFF the robot.
- Reboot and reset: Turn the power switch OFF for 30 seconds, then ON. If your Honiture app offers a sensor calibration or factory reset option, perform it following on-screen instructions.
- Flat surface test: Place the robot on a perfectly flat, stable surface and start a cleaning cycle. Avoid moving it by hand during startup, as this can affect calibration.
- Check for impact damage: Inspect the housing for cracks or signs of a heavy fall, which can damage the IMU module.
- Advanced repair: Open the top cover and locate the small IMU/gyroscope board (often near the center of the main PCB). Ensure its connector is firmly seated. If E10 persists, replace the IMU / Gyroscope Module or the main PCB.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
IMU / Gyroscope Module
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements