Amica

Amica Washer-Dryer Combos Error Codes

Complete list of fault codes and troubleshooting guides. Use the search below to find your specific error.

Advertisements
E01
Washer-dryer will not start; the door symbol flashes and the cycle will not begin.
Door Lock Circuit Fault
E02
Washer-dryer does not fill with water or fills very slowly; E02 is displayed shortly after the cycle starts.
Water Inlet Timeout / Fill Fault
E03
Washer-dryer does not drain; water remains in the drum and E03 is displayed.
Drain Pump Timeout / Drain Fault
E04
Machine overfills or displays E04; the water level is too high, or water is visible in the door glass before the cycle stops.
Overfill / Water Level Sensor Fault
E05
Washer-dryer does not heat water; the cycle runs cold and may extend in duration, with E05 displayed.
Water Heating Circuit Fault
E06
The drying function does not heat; clothes remain wet and cold after the drying cycle, and E06 is displayed.
Dryer Heating Circuit Fault
E07
Washer-dryer stops with E07; the drum does not rotate or rotates erratically during wash or spin.
Motor Tachometer / Speed Sensor Fault
E08
Washer-dryer will not spin; E08 is displayed near the spin phase, and the drum may only tumble slowly.
Unbalanced Load / Spin Protection Fault
E09
Washer-dryer stops mid-cycle with E09; the drum may be locked, and the machine becomes unresponsive.
Motor Power / Triac Short Fault
E10
Washer-dryer displays E10 and will not start or stops shortly after starting
Door Not Closed / Door Switch Signal Fault
E11
Washer-dryer shows E11; water remains in drum and program cannot proceed to spin
Drain Level Not Reached / Pump Performance Fault
E12
Drying cycle stops early with E12; clothes are damp and machine may feel hot
Dryer Condenser / Airflow Fault
E13
Washer-dryer displays E13; water detected in base tray or machine stops and pump runs continuously
Leak Detected / Anti-Flood System Activated
E21
Washer-dryer shows E21; drum does not rotate during wash or spin, humming noise may be heard
Motor Start / Drive Fault
E22
Washer-dryer displays E22; control panel may freeze or buttons unresponsive
User Interface / Communication Fault
E31
Washer-dryer shows E31; incorrect water level readings, machine may not fill or may drain immediately
Pressure Sensor Signal Fault
E32
Washer-dryer intermittently overfills or underfills; E32 displayed
Pressure Sensor Calibration / Range Fault
E40
Door lock symbol flashes; E40 displayed; machine will not start
Door Locking Failure
E41
E41 displayed; machine thinks door is open even when closed
Door Open Signal Fault
E42
Door remains locked at the end of the cycle; E42 displayed.
Door Unlock Fault
E51
Washer-dryer stops with E51; may trip the household breaker in severe cases.
Motor Power Triac Short / Overcurrent Fault
E52
Intermittent spinning; E52 displayed; the drum may jerk or stop unexpectedly.
Motor Tachometer Signal Interruption
E61
Water does not reach the target temperature in time; E61 displayed during wash.
Heating Performance Fault
E62
Water overheats; very hot wash or steam from the door; E62 displayed.
Overheating / Heater Stuck On
E71
E71 displayed; temperature readings are erratic; cycles end too early or too late.
NTC Sensor Circuit Fault
E91
Display panel lights but does not respond correctly; E91 displayed.
Communication Error Between UI and Main PCB
E92
Washer-dryer powers on but cannot be programmed correctly; E92 displayed.
Configuration / EEPROM Fault
Symptom
Clothes come out very wet; spin seems weak or incomplete.
Poor Spin Performance
Symptom
Detergent drawer overflows with water or leaks down the front
Detergent Dispenser Overflow
Symptom
Display shows incorrect time remaining or jumps unexpectedly
Cycle Time Estimation / Sensor Inaccuracy
Symptom
Door glass becomes extremely hot during drying
Excessive Front Panel Heating
Symptom
Door is difficult to open or close; it scrapes or catches.
Door Hinge / Latch Misalignment
Symptom
Dryer section produces burning smell or very hot air
Dryer Overheating
Symptom
Drying cycle takes very long and clothes are still damp
Reduced Drying Efficiency
Symptom
High-pitched squealing or grinding noise when the drum turns.
Drum Bearing or Drive System Wear
Symptom
Softener remains in compartment after cycle
Fabric Softener Siphon Failure
Symptom
Unpleasant musty or moldy smell from drum or during drying
Biofilm / Mold Build-Up
Symptom
Washer-dryer does not drain completely; a small amount of water is always left in the drum.
Partial Drain / Residual Water
Symptom
Washer-dryer drum does not turn at all in wash or spin, but the machine fills and drains.
Drive System Failure
Symptom
Washer-dryer emits electrical or burning plastic smell during operation
Overheating Electrical Component
Symptom
Washer-dryer leaks water from the front during wash.
Door Gasket Leak
Symptom
Washer-dryer leaves detergent residues on clothes or in the drawer.
Poor Rinsing / Detergent Dispensing Fault
Symptom
Washer-dryer makes loud banging or knocking noises during spin.
Suspension / Balance System Failure
Symptom
Washer-dryer stops mid-cycle and will not continue; lights may flash.
Intermittent Power or Control Fault
Symptom
Washer-dryer trips the household circuit breaker or RCD during operation
Electrical Short or Earth Leakage
Symptom
Washer-dryer vibrates excessively and moves across the floor during spin.
Excessive Vibration / Installation Fault
Symptom
Washer-dryer will not power on; no lights or display.
No Power / Supply Fault
Symptom
Washer-dryer will not start cycle; lights are on but the Start button does nothing.
Control Lock / Start Inhibit
Symptom
Water leaking from underneath the washer-dryer during wash or spin.
Internal Hose or Pump Leak
Advertisements