E8
Tosot
High Pressure Protection / Overload Protection
The unit stops and displays E8, often during high-load operation.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Blocked or dirty outdoor condenser coil, Outdoor fan motor failure, Overcharged refrigerant, Non-condensable gases in the system.
How to Fix / Troubleshooting
Safety first: Disconnect power at the outdoor disconnect before working on the unit.
- Clear airflow: Remove any obstructions around the outdoor unit. Maintain at least 2–3 feet of clearance on all sides and above.
- Clean condenser coil: With power off, gently wash the coil fins with water to remove dirt and lint.
- Check outdoor fan: Confirm the fan starts and runs at full speed when the unit is cooling. Replace the fan motor if it fails to run or is noisy and slow.
- Reset system: After cleaning and verifying fan operation, power cycle the system and test again.
- If E8 returns: A technician must check refrigerant pressures. Overcharge or contamination requires recovery, evacuation, and recharging to Tosot specifications.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
Outdoor Condenser Coil
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements