F8
AEG
Anti-Flood / Overfill Fault (Alternate Code Set)
Dishwasher shows F8 and may run the drain pump continuously or not start.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Water in base tray activating float switch, Internal leak from hoses or pump, Over-foaming from detergent on AEG dishwasher
How to Fix / Troubleshooting
Safety first: Disconnect power and be prepared for water spillage when moving the appliance.
- Drain base tray: Pull the dishwasher out and gently tilt it to allow water to escape from the base. Use towels to soak up water.
- Identify leak source: With panels removed, run a short cycle and look for drips from the circulation pump, heater, hoses, or door area.
- Correct detergent use: Ensure only dishwasher tablets or powder are used, not hand-wash liquid.
- Repair leak: Replace any cracked hoses, seals, or components causing the leak.
Advertisements
Repair Difficulty
Hard
4/5
Advertisements