The dishwasher does not take in enough water (short fill); E18 is displayed.

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Possible Causes

Partially closed tap, Clogged inlet filter, Restricted water matrix, Defective inlet valve coil

Safety first: Disconnect the power and close the water tap.

1. Fully open tap: Confirm that the supply tap is fully open and not partially closed.
2. Clean inlet filter: Remove and clean the mesh filter at the hose connection, as described for E02.
3. Check hose for kinks: Straighten any sharp bends or kinks in the inlet hose.
4. Inspect water matrix: Remove the side panel and check for partial blockages in the water matrix. Descale if necessary.

When to call a technician: If E18 persists despite a good water supply, the inlet valve or flow meter may need replacement.

Medium 3/5

Water Inlet Valve

Check Price on Amazon

We may earn a commission from links on this page.