Frigidaire Gallery Drain Pump-Out Mode

Display shows dP; the dishwasher runs a short drain cycle instead of a full wash.

Possible Causes

User-initiated drain program, Control reset sequence triggered, Stuck drain button or key, Software glitch

Safety note: This is usually a normal mode, not a malfunction.

Allow drain to complete: Allow the dP cycle to finish; it is designed to remove standing water.
Start a new cycle: After dP completes, select your desired wash cycle and press Start.
Check buttons: If dP starts unexpectedly, inspect the control panel for stuck or damaged buttons, and clean the surface.
Power reset: Turn off the circuit breaker for 5 minutes to clear any control glitches.

Very Easy 1/5