Hansa Thermal Cut-Out Tripping

Dryer runs only for a few minutes then stops, clothes barely warm

Advertisements

Safety Warning

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Advertisements

Possible Causes

Blocked airflow causing overheating, Weak or faulty thermostat, Partially blocked condenser or vent

How to Fix / Troubleshooting

Safety first: Unplug the dryer and allow it to cool before working on it.

  • Clean all airflow components: Thoroughly clean lint filter, condenser, and exhaust duct.
  • Inspect thermostats: Access the heater housing and test thermostats for correct operation. Replace any that are weak or out of spec.
  • Check installation: Ensure the dryer has adequate clearance from walls and is not installed in a confined, unventilated space.

After restoring airflow and replacing faulty thermostats, test a full cycle. If the cut-out still trips, the heater or control may be overdriving temperature and should be checked professionally.

Advertisements

Repair Difficulty

Medium 3/5

Required Part

Thermal Cut-Out / Thermostat
Check Price on Amazon

We may earn a commission from links on this page.

Advertisements