Kenmore
Motor Run Circuit or Relay Failure.
The dryer runs only when the Start button is held down and stops when released.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
A faulty motor centrifugal switch, a defective motor relay on the control board, or a wiring issue in the run circuit.
How to Fix / Troubleshooting
Safety First: Unplug the dryer and shut off the gas.
Steps:
- Check door and belt switch: Ensure the door switch and belt switch (if equipped) are functioning properly.
- Inspect motor: Access the drive motor and check for loose connections. A failed centrifugal switch inside the motor often requires motor replacement.
- Control relay: On electronic models, the motor run relay on the main control may be defective and require board replacement.
Advertisements
Repair Difficulty
Hard
4/5
Advertisements