Vedette
Vedette Dryers Error Codes
Complete list of fault codes and troubleshooting guides. Use the search below to find your specific error.
Advertisements
E01
Dryer will not start, display shows E01 immediately after pressing Start
Door Lock / Door Switch Fault
E02
Dryer stops shortly after start, E02 displayed, drum may not rotate
Motor Start Failure / Motor Circuit Fault
E03
Dryer stops mid-cycle, E03 displayed, clothes remain wet and cold
Heating Circuit Failure
E04
Dryer displays E04 and stops, often early in the cycle, sometimes with very hot drum
Overheating / Airflow Restriction
E05
Dryer shows E05, cycle ends quickly, clothes remain damp or cold
NTC Temperature Sensor Fault
E06
Dryer displays E06, drum does not rotate although motor hum may be heard
Drive Belt / Drum Rotation Fault
E07
Dryer shows E07 and stops, often accompanied by loud noise or difficulty starting rotation
Motor Overload / Motor Overheating
E08
Dryer displays E08, no heat, fan may run normally
Heater Relay / Power Supply to Heater Fault
E09
Dryer shows E09, will not start, sometimes after a power surge or lightning
Main Control Board Communication / Internal Error
E10
Dryer displays E10 and stops, often on Vedette condenser or heat pump dryers with a water tank.
Condensate Pump / Water Level Fault
E11
Dryer shows E11, often accompanied by beeping and no start.
User Interface / Keypad Fault
E12
Dryer displays E12; the cycle may start but stops unexpectedly, especially on sensor-dry programs.
Moisture Sensor Circuit Fault
E13
Dryer shows E13, often on heat pump Vedette dryers; the unit may stop and not restart until cooled.
Heat Pump System / Compressor Fault
E14
Dryer displays E14; it will not start or stops, sometimes with water in the base tray (on condenser/heat pump models).
Anti-Flood / Leak Detection Fault
E15
Dryer shows E15, beeps, and does not respond to program selection.
Control Panel Communication / EEPROM Error
E16
Dryer displays E16; the drum light may work, but the motor and heater do not start.
Door Locking / Safety Circuit Fault
E17
Dryer shows E17, often on models with a reversible door or advanced safety features.
Door Reversal / Door Position Sensor Fault
E18
Dryer displays E18, often with very long drying times and poor condensation on condenser/heat pump models.
Airflow / Condenser Temperature Fault
Symptom
Dryer display shows an unusually long or short remaining time that does not match actual drying.
Sensor Calibration / Load Detection Issue
Symptom
Dryer display works but buttons are unresponsive or respond intermittently.
User Interface / Keypad Contact Issue
Symptom
Dryer door is difficult to open or close, or there is scraping or grinding at the front.
Front Panel / Drum Alignment Issue
Symptom
Dryer door will not stay closed or pops open during the cycle.
Door Latch / Hinge Wear
Symptom
Dryer drum light stays on even when the door is closed, or never comes on.
Door Switch / Drum Light Circuit Fault
Symptom
Dryer makes a rattling or metallic clinking noise during operation.
Foreign Objects in Drum or Blower
Symptom
Dryer occasionally trips the household circuit breaker or RCD.
Electrical Short or Ground Fault
Symptom
Dryer runs but clothes come out very wrinkled and over-dried.
Moisture Sensing / Program Selection Issue
Symptom
Dryer runs but does not heat; clothes come out cold and wet, and no error code is displayed.
Heating System Failure (No-Code Condition)
Symptom
Dryer runs only on some programs; other programs will not start or end immediately.
Program Logic / Sensor Dependency Issue
Symptom
Dryer stops with water remaining in the condenser area, or the tank does not fill.
Condensate Pump Not Moving Water
Symptom
Dryer vibrates excessively or moves across the floor during operation.
Installation / Support Imbalance
Symptom
The dryer causes condensation or steam in the laundry room; the room becomes very humid.
Exhaust / Condenser Venting Problem
Symptom
The dryer drum does not turn, but you can hear the motor humming when Start is pressed.
Seized Drum or Failed Start Capacitor
Symptom
The dryer emits a burning smell during operation.
Overheating or Foreign Object on Heater
Symptom
The dryer heats but takes a very long time to dry; clothes are warm but still damp at the end of the cycle.
Restricted Airflow / Inefficient Drying
Symptom
The dryer leaks water onto the floor during or after a cycle.
Condensate Drainage / Tank Overflow
Symptom
The dryer makes a loud banging or thumping noise, especially with small loads.
Drum Imbalance / Worn Support Rollers
Symptom
The dryer makes a loud squealing or screeching noise during operation.
Worn Drum Support Components
Symptom
The dryer stops mid-cycle and will not restart until it cools down.
Overheating / Thermal Cut-Out Activation
Symptom
The dryer will not power on at all; no lights, no display, completely dead.
Power Supply / Main Fuse Failure
Symptom
The dryer will not start at all; there is no drum movement, but lights or the display may be on.
Start Circuit / Control Lock Issue
| Error Code | Symptom | Fault Type | Guide |
|---|---|---|---|
| E01 |
Dryer will not start, display shows E01 immediately after pressing Start
|
Door Lock / Door Switch Fault | View Details |
| E02 |
Dryer stops shortly after start, E02 displayed, drum may not rotate
|
Motor Start Failure / Motor Circuit Fault | View Details |
| E03 |
Dryer stops mid-cycle, E03 displayed, clothes remain wet and cold
|
Heating Circuit Failure | View Details |
| E04 |
Dryer displays E04 and stops, often early in the cycle, sometimes with very hot drum
|
Overheating / Airflow Restriction | View Details |
| E05 |
Dryer shows E05, cycle ends quickly, clothes remain damp or cold
|
NTC Temperature Sensor Fault | View Details |
| E06 |
Dryer displays E06, drum does not rotate although motor hum may be heard
|
Drive Belt / Drum Rotation Fault | View Details |
| E07 |
Dryer shows E07 and stops, often accompanied by loud noise or difficulty starting rotation
|
Motor Overload / Motor Overheating | View Details |
| E08 |
Dryer displays E08, no heat, fan may run normally
|
Heater Relay / Power Supply to Heater Fault | View Details |
| E09 |
Dryer shows E09, will not start, sometimes after a power surge or lightning
|
Main Control Board Communication / Internal Error | View Details |
| E10 |
Dryer displays E10 and stops, often on Vedette condenser or heat pump dryers with a water tank.
|
Condensate Pump / Water Level Fault | View Details |
| E11 |
Dryer shows E11, often accompanied by beeping and no start.
|
User Interface / Keypad Fault | View Details |
| E12 |
Dryer displays E12; the cycle may start but stops unexpectedly, especially on sensor-dry programs.
|
Moisture Sensor Circuit Fault | View Details |
| E13 |
Dryer shows E13, often on heat pump Vedette dryers; the unit may stop and not restart until cooled.
|
Heat Pump System / Compressor Fault | View Details |
| E14 |
Dryer displays E14; it will not start or stops, sometimes with water in the base tray (on condenser/heat pump models).
|
Anti-Flood / Leak Detection Fault | View Details |
| E15 |
Dryer shows E15, beeps, and does not respond to program selection.
|
Control Panel Communication / EEPROM Error | View Details |
| E16 |
Dryer displays E16; the drum light may work, but the motor and heater do not start.
|
Door Locking / Safety Circuit Fault | View Details |
| E17 |
Dryer shows E17, often on models with a reversible door or advanced safety features.
|
Door Reversal / Door Position Sensor Fault | View Details |
| E18 |
Dryer displays E18, often with very long drying times and poor condensation on condenser/heat pump models.
|
Airflow / Condenser Temperature Fault | View Details |
| – |
Dryer display shows an unusually long or short remaining time that does not match actual drying.
|
Sensor Calibration / Load Detection Issue | View Details |
| – |
Dryer display works but buttons are unresponsive or respond intermittently.
|
User Interface / Keypad Contact Issue | View Details |
| – |
Dryer door is difficult to open or close, or there is scraping or grinding at the front.
|
Front Panel / Drum Alignment Issue | View Details |
| – |
Dryer door will not stay closed or pops open during the cycle.
|
Door Latch / Hinge Wear | View Details |
| – |
Dryer drum light stays on even when the door is closed, or never comes on.
|
Door Switch / Drum Light Circuit Fault | View Details |
| – |
Dryer makes a rattling or metallic clinking noise during operation.
|
Foreign Objects in Drum or Blower | View Details |
| – |
Dryer occasionally trips the household circuit breaker or RCD.
|
Electrical Short or Ground Fault | View Details |
| – |
Dryer runs but clothes come out very wrinkled and over-dried.
|
Moisture Sensing / Program Selection Issue | View Details |
| – |
Dryer runs but does not heat; clothes come out cold and wet, and no error code is displayed.
|
Heating System Failure (No-Code Condition) | View Details |
| – |
Dryer runs only on some programs; other programs will not start or end immediately.
|
Program Logic / Sensor Dependency Issue | View Details |
| – |
Dryer stops with water remaining in the condenser area, or the tank does not fill.
|
Condensate Pump Not Moving Water | View Details |
| – |
Dryer vibrates excessively or moves across the floor during operation.
|
Installation / Support Imbalance | View Details |
| – |
The dryer causes condensation or steam in the laundry room; the room becomes very humid.
|
Exhaust / Condenser Venting Problem | View Details |
| – |
The dryer drum does not turn, but you can hear the motor humming when Start is pressed.
|
Seized Drum or Failed Start Capacitor | View Details |
| – |
The dryer emits a burning smell during operation.
|
Overheating or Foreign Object on Heater | View Details |
| – |
The dryer heats but takes a very long time to dry; clothes are warm but still damp at the end of the cycle.
|
Restricted Airflow / Inefficient Drying | View Details |
| – |
The dryer leaks water onto the floor during or after a cycle.
|
Condensate Drainage / Tank Overflow | View Details |
| – |
The dryer makes a loud banging or thumping noise, especially with small loads.
|
Drum Imbalance / Worn Support Rollers | View Details |
| – |
The dryer makes a loud squealing or screeching noise during operation.
|
Worn Drum Support Components | View Details |
| – |
The dryer stops mid-cycle and will not restart until it cools down.
|
Overheating / Thermal Cut-Out Activation | View Details |
| – |
The dryer will not power on at all; no lights, no display, completely dead.
|
Power Supply / Main Fuse Failure | View Details |
| – |
The dryer will not start at all; there is no drum movement, but lights or the display may be on.
|
Start Circuit / Control Lock Issue | View Details |
No matching codes found
Advertisements