The freezer runs continuously and never cycles off, but the temperature is acceptable.

Safety: Always unplug the appliance before adjusting hinges or replacing gaskets.

Steps:

• 1. Check door closure: Close the door on a sheet of paper at several points around the gasket. If the paper pulls out easily, the seal is weak in that area.
• 2. Inspect gasket: Look for splits, deformation, or gaps. Warm the gasket gently with a hair dryer (on low setting) and reshape it to improve sealing. If badly damaged, replace the "Amica Freezer Door Gasket".
• 3. Level and hinge adjustment: Ensure the freezer is level and the door is not sagging. Adjust the front feet and hinge screws so the door self-closes from a slightly open position.
• 4. Check settings: Turn off fast-freeze mode and set the thermostat to a moderate setting. Monitor if the compressor begins to cycle.
• 5. Control fault: If the unit still runs continuously with good sealing and normal settings, the thermostat or control board may be faulty and require replacement.

Tip: Continuous running increases energy consumption and wear on the compressor.