E17
Westinghouse
Fast-Freeze Circuit Fault
Freezer shows E17 and may not enter or exit fast-freeze / quick-freeze mode.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Stuck fast-freeze relay on control board, Faulty fast-freeze button or switch, Wiring fault between UI and main board, Control board failure
How to Fix / Troubleshooting
Safety: Disconnect power before working on the control system.
Steps:
- Check fast-freeze button: Ensure the button is not physically stuck. Clean around it if necessary.
- Inspect control panel: Remove and check for cracked solder joints or moisture damage around the fast-freeze switch.
- Control board check: Access the main board and inspect the relay associated with fast-freeze (refer to wiring diagram). Look for burn marks.
- Replace faulty parts: Replace the user interface board if the button is defective. If the relay is stuck or burnt, replace the main control board.
Advertisements
Repair Difficulty
Medium
3/5
Required Part
Fast-Freeze Button / User Interface Board
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements