Opener lights flash ten times and the door will not move; this may occur after installing LED bulbs or accessories.

Safety first: Disconnect power before changing bulbs or accessory wiring. Use only bulbs and accessories approved for Craftsman openers.

• Remove non-approved bulbs: Replace any high-wattage or non-garage-rated LED bulbs with Craftsman-approved LED or incandescent bulbs within the wattage limit specified on the opener.
• Disconnect accessories: Remove all add-on devices (e.g., smart controllers, extra keypads, car sensors) from the accessory terminals on the logic board.
• Power cycle: Plug the opener back in and test operation with only the basic wall control and safety sensors connected. If the 10-flash code clears, the issue is with an accessory.
• Reconnect one at a time: Reconnect accessories individually, testing after each. When the error returns, the last connected device or its wiring is the culprit.
• Correct wiring or replace accessory: Verify wiring polarity and terminal placement for the problematic accessory. Replace it if it appears damaged or incompatible.