Dehumidifier displays P2 and stops running; the bucket is full or nearly full.

Safety: Turn the unit off and unplug before removing the bucket.

Steps to clear P2:

• Empty the bucket: Carefully slide out the water bucket, empty it, and reinstall it fully until it clicks into place.
• Check bucket position: Ensure the bucket is not warped and that it sits flat against the internal switch lever or float mechanism.
• Inspect float and switch: Inside the bucket compartment, locate the bucket full float and the bucket full switch. Make sure the float moves freely and is not stuck by dirt or scale.
• Continuous drain users: If using a hose, confirm the hose is not kinked or clogged and that it slopes downward to a drain. A blocked hose can cause the bucket to fill and trigger P2.
• Switch test (advanced): With the unit unplugged, access the bucket full switch and check continuity with a multimeter while actuating the lever. Replace the bucket full switch if it does not change state.