Ice maker indicates a pump error, resulting in no water circulation over the evaporator.

Safety first: Always disconnect power and shut off the water supply before servicing the pump.

• Access the pump: Remove the front panel and ice bin. Locate the circulation pump in the reservoir area.
• Inspect for debris: Remove the pump cover or inlet screen and clear any debris or scale buildup.
• Bleed air: Refill the reservoir and tilt the unit slightly, if needed, to help purge air from the pump.
• Test the pump: With the pump disconnected, measure motor resistance. If open, replace the pump. Briefly apply power (following safety procedures) to confirm operation.
• Check wiring: Ensure the pump harness is secure and not damaged.
• Replace the pump: Install a new OEM Maytag circulation pump if defective, ensuring all seals and gaskets are properly seated to prevent leaks.