F0E0
Maytag
Control board configuration or internal error
F0E0 error, general control fault, oven may not operate correctly.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Incorrect control configuration, corrupted firmware, failed EOC, power surge
How to Fix / Troubleshooting
Safety First: Turn off power before removing the control panel.
- Power reset: Turn the circuit breaker OFF for 5–10 minutes, then back ON. Observe if the error reappears.
- Check model configuration: Some Maytag controls require configuration codes after replacement. Verify the correct code is programmed according to the tech sheet (usually behind the control panel).
- Inspect control: Inspect the EOC for visible damage. If present, replace the board.
- Replace EOC: If configuration is correct and F0E0 persists, replace the Electronic Oven Control board.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
Electronic Oven Control Board (EOC)
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements