Variable-speed pump runs only at one speed and ignores programmed schedules.

Safety: No internal electrical work is required for programming, but do not open the drive with power on.

• Check control mode: Verify whether the Sta-Rite pump is set to be controlled by its keypad or by an external automation system. If under external control, schedules must be set in the automation panel.
• Review schedules: Go through each programmed speed and time period on the pump and correct any overlapping or disabled schedules.
• Factory reset: Perform a factory reset of the pump’s programming per the manual, then re-enter desired speeds and times.
• Test operation: Observe the pump over a full schedule cycle to confirm it changes speeds as programmed.