Alarm 007
Pentair
Internal Communication Error
IntelliFlo3 VSF or similar Pentair pump shows “Alarm 007” and will not run.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Faulty control keypad/display board, Failed communication bus inside drive, Corrupted configuration data, Power supply instability within drive
How to Fix / Troubleshooting
Safety first: Disconnect power before removing the keypad or drive cover.
- Step 1 – Reseat keypad/display: Remove the keypad/display module (if removable) and reseat its connector to ensure good contact.
- Step 2 – Power reset: Turn off power for several minutes, then restore and check if Alarm 007 clears.
- Step 3 – Replace keypad (if available): On some models, the keypad/display can be replaced separately. Try a known‑good keypad if available.
- Step 4 – Replace drive: If the alarm persists, the internal communication bus or logic board is likely defective. Replace the drive module.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
IntelliFlo3 Keypad/Display Module
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements