F10 error: oven overheats or temperature climbs far above the set point.

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Possible Causes

Shorted oven sensor, failed EOC temperature circuit, or a relay on the control board stuck closed.

Safety: If the oven is overheating, shut off the breaker immediately.

Test sensor: As with F2/F3, check the oven temperature sensor resistance at room temperature (~1080 Ω). Replace if out of spec.
Check sensor at high temp: If possible, heat the sensor tip gently with a heat gun while monitoring resistance; it should increase smoothly. Erratic readings indicate a bad sensor.
Inspect control board: Look for burnt spots near the bake/broil relays. If relays appear welded or the board is damaged, replace the EOC.
Do not use self-clean: Until resolved, avoid self-clean cycles which stress the sensor and control.

Hard 4/5

Electronic Oven Control Board.

Check Price on Amazon

We may earn a commission from links on this page.