E0-F5
Kenmore
Watchdog / Control Board Failure
The range displays E0-F5, and the oven may not start.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Internal control board fault, power supply issue to the control, corrupted firmware.
How to Fix / Troubleshooting
Safety first: Turn off power at the breaker.
- Power reset:
- Leave power off for 10 minutes, then restore.
- If E0-F5 returns, the control is likely defective.
- Inspect control board:
- Remove the back panel and inspect for burnt components or damaged traces.
- Replace control:
- Replace the electronic oven control (EOC) following the wiring diagram.
Advertisements
Repair Difficulty
Medium
3/5
Required Part
Electronic Oven Control Board
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements