Tecnogas range shows E8 and the clock or timer cannot be set; oven functions may be disabled.
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Possible Causes
How to Fix / Troubleshooting
Safety first: Turn off power at the breaker before removing the control panel.
Steps:
- Power cycle: Disconnect power for at least 10 minutes to allow any residual charge in capacitors to dissipate. Restore power and attempt to set the clock again.
- Check supply voltage: Ensure the range is connected to a stable power source with the correct voltage (as per the Tecnogas rating plate). Undervoltage can cause clock errors.
- Inspect control board: Remove the rear cover and visually inspect the EOC for burnt components or bulging capacitors.
If E8 returns after a proper reset and supply is correct, the control board’s memory or clock circuit is likely damaged and the EOC should be replaced.
Repair Difficulty
Required Part
We may earn a commission from links on this page.