Washer-dryer does not detect the water level correctly, may not fill or may overfill, and displays F10.
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Possible Causes
How to Fix / Troubleshooting
Safety first: Disconnect the appliance from the mains and close the water taps.
Check the sensor and hose:
- Inspect hose: As with F04, ensure the thin pressure hose is clear and properly connected.
- Check sensor connector: Reseat the multi-pin plug on the analog pressure sensor.
- Visual inspection: Look for water ingress into the sensor body; if present, the sensor must be replaced.
Replace sensor: If the hose is clear and the wiring is intact but F10 persists, replace the analog pressure sensor and test a full wash cycle.
Repair Difficulty
Required Part
We may earn a commission from links on this page.