The washer-dryer combo displays E32 and may exhibit erratic filling or spinning behavior.

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Possible Causes

Incorrect pressure sensor signal range, Water trapped in the pressure hose, Faulty pressure sensor, Control board misreading the sensor

Safety: Unplug the appliance.

1. Drain the machine completely: Run a drain/spin cycle or manually drain via the pump filter to ensure no residual water remains in the tub.
2. Clear pressure hose: Remove the hose from the sensor and blow gently to remove any trapped water. Ensure the hose slopes downward from the sensor to the tub without sags.
3. Inspect sensor: Check for physical damage or water inside the sensor body. Replace if contaminated or cracked.

Some models may require a service calibration procedure using manufacturer tools. If E32 persists, contact an Electrolux service center.

Hard 4/5

Pressure Sensor

Check Price on Amazon

We may earn a commission from links on this page.