Kenmore Dryer or Water Temperature Sensor Error

Washer-dryer combo displays 'tE' during drying or heating wash cycles.

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Possible Causes

An open or shorted dryer thermistor, a wiring issue to the thermistor, or a failed control board temperature circuit.

Safety first: Disconnect power and allow the unit to cool.

Locate thermistor: On combo units, the dryer thermistor is usually on the blower housing or exhaust duct. Remove the rear panel to access it.
Inspect wiring: Check the thermistor connector and harness for damage. Reseat the connector.
Test thermistor: Measure resistance at room temperature and compare to service specifications (often 10–50kΩ). Replace if readings are out of range or if open/shorted.

Medium 3/5

Dryer Thermistor

Check Price on Amazon

We may earn a commission from links on this page.