E10
Proline
General Water Supply/Level Fault
Washer-dryer stops with E10, often associated with water inlet or level issues at the start of the cycle.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Partially blocked inlet valve, faulty pressure switch, loose pressure hose, control board misreading water level
How to Fix / Troubleshooting
Safety first: Unplug the appliance and close the water tap before working on hoses.
Step-by-step checks:
- Repeat E02/E04 checks: Verify the water supply, clean inlet filters, and ensure the pressure hose and switch are functioning as described for E02 and E04.
- Check for leaks in the pressure hose: Even small splits can cause incorrect level readings. Replace the hose if any damage is found.
- Run a test cycle: After cleaning and checking, run a short wash to see if E10 reappears. Observe the fill and initial drum movements.
- Control board: Persistent E10, with all mechanical parts verified, may indicate a PCB fault.
When to call a technician: If you cannot identify a clear mechanical cause, professional diagnostics are advised.
Advertisements
Repair Difficulty
Medium
3/5
Required Part
Water Level Pressure Switch
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements