Washer shows F3E3 and may not fill correctly or may stop during sensing phase.

Safety: Turn off water supply and unplug the washer before disconnecting hoses.

• Verify hose connections: Confirm the hot hose is connected to the hot faucet and the hot inlet on the washer (usually marked red or "H"), and cold to cold.
• Check water flow:
  • Turn off faucets, remove hoses from the back of the washer.
  • Place hoses in a bucket and briefly open faucets to confirm strong flow from both hot and cold.
  • Clean inlet screens on the washer's water valves of any sediment.
• Run a test cycle: Reconnect hoses, turn on water, and run a warm wash. If F3E3 returns, continue.
• Inspect inlet valve assembly: Access the rear/top of the washer and check the hot/cold inlet valve wiring and connectors. Reseat connectors.
• Replace inlet valve assembly if needed: If one side is not opening or the valve's internal sensor is faulty, replace the complete Amana inlet valve assembly.