F7E6
Amana
Motor Circuit or Motor Drive Fault
Washer shows F7E6 and may not agitate; motor may run but basket does not move correctly.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Partially failed drive motor, loose motor connector, damaged motor capacitor (if equipped), main control motor driver failure
How to Fix / Troubleshooting
Safety: Disconnect power before accessing the motor or control board.
- Inspect motor wiring: Remove the rear or bottom panel and check the motor harness for loose or burnt connectors. Reseat firmly.
- Check for burnt smell: A burnt odor near the motor indicates overheating or winding failure; replacement is recommended.
- Test motor (if equipped with capacitor): Inspect the start/run capacitor for bulging or leakage. Replace if defective.
- Run diagnostic mode: Use the tech sheet to enter diagnostics and run motor tests. If the motor fails to run in one direction, replace the motor assembly.
If the motor and capacitor test good, the main control board's motor drive circuit may be defective and require replacement.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
Drive Motor Assembly
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements