E23
Beko
Drain Pump Control Fault
The washer shows E23; this is often related to a drain pump triac or an electrical fault.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Shorted drain pump, shorted triac on PCB, wiring short to pump, water ingress into pump connector.
How to Fix / Troubleshooting
Safety first: Unplug the washer before working on electrical parts.
Step-by-step checks:
- Inspect the pump and connector: Check for signs of burning, melting, or corrosion at the pump terminals.
- Test the pump coil: Measure the resistance across the pump terminals. Replace the pump if it is open or significantly out of spec.
- Check the wiring: Inspect the harness from the pump to the PCB for damage or shorts to the chassis.
If the pump and wiring are good, the PCB pump triac is likely damaged and the board will need repair or replacement.
Advertisements
Repair Difficulty
Hard
4/5
Advertisements