E10
Candy
Water Fill / Pressure Switch Communication Error
Washer does not fill correctly or shows E10 at start of cycle.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Loose pressure switch connector, Faulty pressure switch, Wiring fault between pressure switch and PCB, Control board input failure
How to Fix / Troubleshooting
Safety: Unplug the washer before removing the top cover.
- Access pressure switch: Remove the top panel. Locate the round pressure switch with a small hose and electrical connector.
- Check connections: Ensure the electrical plug is fully seated and the terminals are not corroded. Reseat the connector.
- Inspect hose: Confirm the pressure hose is firmly attached and not split or kinked.
- Test switch: With a multimeter, check for continuity changes across the switch terminals while gently blowing into the pressure port. Replace if no change is detected.
If the pressure switch and wiring are good, the PCB may not be reading the signal correctly and will likely need replacement by a technician.
Advertisements
Repair Difficulty
Medium
3/5
Required Part
Pressure Switch
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements