E41
Comfee
Door Open Signal Error
Washer shows E41 even though the door appears closed; cycle will not start.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Faulty door position switch inside lock, Misaligned door causing intermittent contact, Loose harness at control board, Defective main PCB input
How to Fix / Troubleshooting
Safety first: Disconnect power before accessing the control or lock.
- Check for play in door: Gently lift the door when closed. Excessive movement can prevent the internal switch from closing. Tighten hinges if loose.
- Inspect lock wiring: Access the door lock and verify the harness is fully seated and not corroded.
- Continuity test: With the door closed, test continuity across the door-closed switch terminals. If the switch does not close, replace the door lock assembly.
- Control input: If the lock tests good, inspect the main PCB connector for bent pins or damage. A faulty PCB input may require board replacement.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
Door Lock Assembly
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements