Washer will not start; F22 displayed; door appears closed but machine thinks it is open.

Safety first: Unplug the washer before working around the door lock.

Check door alignment and strike:

• Close the door slowly and observe if it latches firmly. If you must lift or push the door to latch, hinges may be loose or bent.
• Inspect the door strike for cracks or wear. Replace if damaged.

Inspect door lock assembly:

• Remove the front gasket clamp and access the door lock as described in the F13 procedure.
• Verify the connector is fully seated and wires are not broken.
• Test the lock coil for continuity with a multimeter. Replace the lock if open or if there are signs of overheating.

After replacement: Reinstall the lock and gasket, ensuring a watertight seal. Plug in the washer and test a short cycle to confirm the door locks and F22 is cleared.