F35
Crosley
Analog Pressure Sensor Error
Washer displays F35; may also show Sud/Sd; issues with water level and suds detection.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Failed analog pressure sensor, blocked pressure hose, excessive suds interfering with pressure reading, control board fault
How to Fix / Troubleshooting
Safety first: Unplug the washer.
Reduce suds:
- If there are visible excessive suds, run a Rinse/Spin cycle with no detergent to clear the tub. Use only HE (high-efficiency) detergent in Crosley HE washers.
Inspect analog pressure sensor:
- Locate the analog pressure sensor (often a small electronic module with a hose attached, near the top of the cabinet).
- Remove and clear the pressure hose as in F08.
- Inspect the sensor for water intrusion or corrosion. Replace if contaminated or if F35 persists after hose cleaning.
If sensor and hose are good, the main control may be misreading the analog signal and require replacement.
Advertisements
Repair Difficulty
Medium
3/5
Required Part
Analog Pressure Sensor
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements