Crosley Overfilling / Flooding

Washer overfills or continues to fill with water even when unplugged.

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Possible Causes

Stuck-open water inlet valve, blocked pressure hose, failed pressure switch, siphoning from drain hose installed too low

Emergency action: Immediately turn off both hot and cold water supply valves and unplug the washer.

Check inlet valve:

With the washer unplugged and water valves turned back on briefly, observe if water still enters the tub. If so, the inlet valve is mechanically stuck open and must be replaced.

Inspect pressure system and drain hose:

Follow the pressure hose and switch checks in F08.
Ensure the drain hose is installed at the correct height (usually 30–96 inches above floor) to prevent siphoning.

Medium 3/5

Water Inlet Valve Assembly / Water Level Pressure Switch

Check Price on Amazon

We may earn a commission from links on this page.