Dawlance washer shows E50; motor does not run or runs erratically.

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Possible Causes

Loose motor connector, Faulty motor winding, Defective motor control PCB, Worn carbon brushes (if applicable)

Safety first: Unplug the washer before accessing the motor.

Inspect motor and connectors: Remove the rear panel and check that the motor plug is fully seated and free of corrosion.
Check brushes (if fitted): Remove the motor and inspect carbon brushes. Replace if worn short.
Test motor windings (advanced): Measure resistance between motor terminals according to Dawlance service data. Replace the motor if windings are open or shorted.

If the motor tests good, the main PCB motor driver may be faulty and should be replaced by a professional.

Professional Required 5/5

Drive Motor Assembly

Check Price on Amazon

We may earn a commission from links on this page.