Dawlance Water Level Control Failure

Washer overfills and water level is higher than normal without showing an error code.

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Possible Causes

Stuck-open water inlet valve, Blocked or disconnected pressure hose, Faulty water level sensor, Control board not shutting off valve

Safety first: Unplug the washer and close the water tap immediately to stop filling.

Drain excess water: Use the drain filter or hose to remove water from the drum.
Inspect inlet valve: With the machine unplugged, open the tap briefly. If water flows into the drum, the valve is stuck and must be replaced.
Check pressure hose and sensor: Ensure the hose is securely attached and not blocked. Replace the sensor if it does not respond correctly.

Persistent overfilling requires professional diagnosis of the control board.

Hard 4/5

Water Level Pressure Sensor

Check Price on Amazon

We may earn a commission from links on this page.