Defy Siphoning or Faulty Water Level Detection

Washer fills and drains repeatedly without progressing in the cycle

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Possible Causes

Drain hose installed too low, Drain hose inserted too far into standpipe, Blocked or kinked pressure sensor hose, Faulty pressure sensor

Safety first: Unplug the washer before adjusting hoses.

Correct drain hose height: Ensure the hose end is at the recommended height (usually 60–100 cm).
Adjust insertion: Pull the hose back so only a short section enters the standpipe.
Inspect pressure hose (advanced): Check for kinks or blockages and reseat the hose on the pressure sensor and tub.

If behaviour persists, the pressure sensor may need replacement.

Medium 3/5

Water Level Pressure Sensor

Check Price on Amazon

We may earn a commission from links on this page.