E38
Electrolux
Blocked Air Trap / Pressure Chamber Fault
Washer displays E38; incorrect water level detection; may not spin or may drain unexpectedly.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Soap and lint buildup in air trap on outer tub, Blocked pressure hose, Restricted vent in tub air chamber, Faulty pressure sensor
How to Fix / Troubleshooting
Safety: Unplug the washer and remove the back or front panel as needed.
- Locate air trap: On many Electrolux models, a plastic air chamber is attached to the side or bottom of the outer tub with the pressure hose connected.
- Clean the chamber: Remove the hose and the air trap if possible. Rinse thoroughly with hot water to remove sludge and detergent residue. Use a small brush if needed.
- Flush the hose: Blow through the hose or run water through it to ensure it is clear.
- Reassemble and test: Refit the air trap and hose securely. Run a rinse/spin cycle to verify normal operation.
Advertisements
Repair Difficulty
Medium
3/5
Required Part
Tub Air Trap / Pressure Chamber
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements