E40
Electrolux
Door Lock / Door Not Properly Closed
Washer will not start; E40 displayed; door appears closed but cycle will not begin.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Misaligned door latch, Faulty door lock assembly, Obstruction on door seal preventing closure, Loose wiring to door lock
How to Fix / Troubleshooting
Safety: Disconnect power before removing the door lock assembly.
- Check door closure: Open and firmly close the door. Ensure no clothing is trapped between the door and the gasket.
- Inspect latch and strike: Examine the metal or plastic strike on the door and the latch opening on the cabinet. Tighten any loose screws and ensure proper alignment.
- Clean gasket area: Wipe the door boot and latch area to remove detergent buildup that may prevent full engagement.
- Test door lock: If E40 persists, remove the front panel or gasket clamp to access the door lock assembly. Check the wiring connector and replace the lock if it shows signs of burning or mechanical failure.
Advertisements
Repair Difficulty
Medium
3/5
Required Part
Door Lock Assembly
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements