E60
Electrolux General Heating System Fault

Washer-dryer combo or washer with heater shows E60; water not heating correctly.

Advertisements

Safety Warning

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Advertisements

Possible Causes

Failed heating element, Faulty NTC temperature sensor, Wiring issue to heater, Control board heater relay fault

How to Fix / Troubleshooting

Safety: Unplug the washer and ensure water is cool before working near the heater.

  • Check for hot wash: Run a hot cycle and feel the door glass after 15–20 minutes. If it remains cold, the heater may not be working.
  • Access heater: On many Electrolux models, the heater is located at the bottom front or rear of the tub. Remove the rear or front panel to access.
  • Test element (advanced): Use a multimeter to measure resistance across the heater terminals. An open circuit indicates a failed element.
  • Inspect wiring and NTC: Ensure connectors are tight and the NTC sensor (often mounted in the heater bracket) is properly seated.

Heater or control board replacement should follow Electrolux service procedures.

Advertisements

Repair Difficulty

Hard 4/5

Required Part

Heating Element
Check Price on Amazon

We may earn a commission from links on this page.

Advertisements