Washer shows E62; overheating detected; water gets excessively hot.

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Possible Causes

Shorted heater relay on control board, Faulty NTC sensor reading too low, Wiring short causing heater to stay energized

Safety: Unplug the washer immediately and allow it to cool before inspection.

Inspect NTC sensor: Check for loose or damaged wiring at the temperature sensor. Replace if suspect.
Control board: If the heater energizes when it should not (verified by a technician), the control board relay is likely stuck and the board must be replaced.

Professional Required 5/5

NTC Temperature Sensor

Check Price on Amazon

We may earn a commission from links on this page.