Washer shows E70; temperature sensor circuit error.

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Possible Causes

Open or shorted NTC sensor, Loose NTC connector, Damaged wiring harness, Control board analog input fault

Safety: Unplug the washer.

Locate NTC: Usually mounted in the heater bracket or tub wall. Access via rear or front panel.
Check connection: Ensure the NTC plug is secure and free of corrosion.
Measure resistance: Use a multimeter to check NTC resistance at room temperature and compare to Electrolux specs. Replace if open, shorted, or out of range.

If a new NTC does not clear E70, the control board may be faulty.

Medium 3/5

NTC Temperature Sensor

Check Price on Amazon

We may earn a commission from links on this page.