Electrolux
Door Lock Stuck / No Unlock
Washer door will not unlock at end of cycle; clothes are trapped inside.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Failed door lock mechanism, Control not sending unlock signal, Water still detected in drum, Pressure sensor indicating full tub
How to Fix / Troubleshooting
Safety: Unplug the washer. Do not force the door open with tools; you may damage the latch or glass.
- Wait and reset: Allow 5–10 minutes after cycle end; some locks delay opening. Then unplug for a few minutes and plug back in.
- Check for water: If water remains in the drum, run a drain/spin cycle. A full tub will keep the door locked.
- Use emergency release: Access the manual door release (often a pull cord or lever near the lock behind the lower front panel or gasket).
- Replace lock: If the problem recurs, replace the door lock assembly.
Advertisements
Repair Difficulty
Medium
3/5
Required Part
Door Lock Assembly
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements