F2
Haier
Water Level / Overflow Fault (Top-Load)
Top-load Haier washer displays F2; water level sensor or overflow issue.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Blocked pressure hose, Faulty pressure switch, Stuck inlet valve, Incorrect drain hose installation causing siphon
How to Fix / Troubleshooting
Safety first: Unplug the washer and shut off water supply.
- Inspect pressure hose and switch: Access the control area under the top panel. Remove and clear the pressure hose and check the switch for clicking when pressure is applied.
- Check inlet valves: Ensure valves close fully when power is off. Replace if water continues to flow.
- Verify drain hose height: Ensure the hose is not too low or inserted too far into the drain, which can cause siphoning.
- Replace pressure switch if needed: If the switch does not respond to pressure changes, install a new Haier-compatible water level switch.
Advertisements
Repair Difficulty
Medium
3/5
Required Part
Water Level Pressure Switch
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements