Washer displays E07 and will not start or stops mid-cycle; often associated with door lock or safety system.

Safety first: Disconnect power before touching the door lock or wiring.

• Visual inspection: Remove the front gasket clamp and pull back the door seal to access the door lock. Check for signs of moisture, corrosion, or burning at the lock and connector.
• Dry and clean: If moisture is present, dry the area thoroughly. Clean light corrosion from terminals with contact cleaner and a soft brush.
• Check wiring continuity: With a multimeter, test continuity of each wire from the door lock connector to the main control module plug. Repair or replace any broken or high-resistance wires.
• Replace door lock if shorted: If the lock shows very low resistance between supply and signal pins or has visible damage, replace the door lock assembly with a Hansa-compatible part.
• Control module check: If a new lock and good wiring still result in E07, the control module input circuit may be damaged. Board repair or replacement is typically required.