E41
Hansa
Door Lock Signal Fault
Washer shows E41; door lock signal error.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Defective door lock microswitch, Loose door lock connector, Broken wire in door lock circuit, Faulty control module input
How to Fix / Troubleshooting
Safety first: Disconnect power before working on the door lock.
- Access door lock: Remove the front gasket clamp and pull back the seal to reach the lock.
- Check connector: Ensure the multi-pin connector is fully inserted and not oxidized. Clean contacts if needed.
- Test lock microswitch: With the lock removed, operate it manually and test continuity across the switch terminals. Replace the door lock assembly if the switch does not change state reliably.
- Inspect wiring: Check for broken or pinched wires between the lock and control board. Repair or replace as necessary.
Advertisements
Repair Difficulty
Medium
3/5
Required Part
Door Lock Assembly
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements