F16
Hotpoint
Drum Position Sensor / Lock Fault (Top Loader)
On some Hotpoint top-loading models: drum will not lock in position; F16 displayed; lid may not open or close correctly.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Faulty drum position sensor, Jammed drum mechanism, Wiring fault to position sensor, Faulty control board input
How to Fix / Troubleshooting
Safety first: Unplug the washer. Do not force the lid or drum.
F16 is specific to certain Hotpoint top-loaders.
- Check for mechanical jams: Ensure no clothing is trapped in the drum mechanism. Gently rotate the drum by hand if possible.
- Access position sensor: Remove the top and side panels to locate the drum position sensor near the drum shaft.
- Inspect wiring: Check the sensor connector and wiring for damage or looseness. Reseat the connector.
- Sensor test: If you have the service manual, follow the specified resistance or voltage tests for the sensor. Replace if out of specification.
- Control board: If the sensor and wiring are good, the control board may not be reading the signal correctly and may require replacement.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
Drum Position Sensor
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements