The washer does not fill with water; F17 is displayed; you may hear a click, but no water flows.

Safety first: Unplug the washer and turn off the water tap before disconnecting hoses.

F17 indicates a filling problem.

• Check the water supply: Ensure the tap feeding the washer is fully open and that household water pressure is adequate. Test by filling a bucket from the same tap.
• Clean the inlet filters: Turn off the tap and disconnect the inlet hose from the back of the washer. Inside the valve are small mesh filters; gently remove and clean them under running water.
• Inspect the hose: Check the inlet hose for kinks or internal blockages. Replace if damaged.
• Test the inlet valve: With the machine unplugged, access the inlet valve from the top/rear. Check the electrical connector is secure. Measure coil resistance (typically 3–5 kΩ). If open circuit, replace the valve.
• Reassemble and test the unit: Reconnect hoses, turn on water, restore power, and run a fill cycle.