Washer will not fill with water; display shows E nF or fills very slowly then errors out.

Safety: Unplug the washer and turn off both hot and cold water supply valves before disconnecting hoses.

• Check supply: Confirm both hot and cold faucets are fully open and household water pressure is adequate.
• Clean inlet screens: Disconnect the fill hoses from the back of the washer. Inspect the small metal screens inside the valve ports and remove debris with a small brush. Do not puncture the screens.
• Test water flow: Briefly run water from the hoses into a bucket to ensure strong flow from the house plumbing.
• Valve test: With power disconnected, access the water inlet valve. Measure coil resistance with a multimeter; an open coil indicates a failed valve that must be replaced.
• Check pressure hose: Inspect the small rubber hose from the tub to the pressure sensor for kinks, cracks, or blockages. Clear or replace as needed.