Huebsch Tub Bearing Failure

Washer emits a loud grinding or rumbling noise, especially during spin.

Advertisements

Safety Warning

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Advertisements

Possible Causes

Worn rear tub bearings, Failed tub seal allowing water into bearings, Damaged drive shaft, Loose drum pulley

How to Fix / Troubleshooting

Safety: Unplug the washer before disassembly; this repair is extensive.

  • Spin test: Rotate the drum by hand. A rough, growling sound or side-to-side play indicates bearing wear.
  • Inspect pulley: Remove rear panel and check that the drum pulley is tight and not wobbling. Tighten or replace if loose or cracked.
  • Seal and bearing replacement: If bearings are noisy, the rear tub half and seal typically must be replaced as an assembly on many Huebsch models.
  • Consider professional service: Bearing replacement requires significant disassembly and special tools; many homeowners opt for a technician.
Advertisements

Repair Difficulty

Professional Required 5/5

Required Part

Rear Tub Assembly with Bearings
Check Price on Amazon

We may earn a commission from links on this page.

Advertisements