Washer displays F30 and may not dispense detergent or softener correctly.

Safety First: Unplug the washer and turn off water supply.

Step-by-step checks:

• 1. Remove and clean drawer: Pull out the dispenser drawer, press the release tab, and remove it completely. Soak and scrub away detergent buildup.
• 2. Inspect dispenser housing: Check for mold, hardened detergent, or foreign objects blocking water flow. Clean thoroughly.
• 3. Check dispenser motor (if rotary type): Remove the top panel and locate the dispenser motor on the housing. Inspect wiring and test motor resistance. Replace if open or seized.
• 4. Verify water flow: With hoses reconnected and water on, briefly run a fill cycle (with cabinet reassembled and safe) to confirm water enters the dispenser properly.

Note: If the motor and housing are clean but F30 persists, the control board output to the dispenser motor may be faulty.