Washer displays F35 and may not start or may stop during fill; analog pressure sensor error on some Inglis models.

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Possible Causes

Defective analog pressure sensor, blocked pressure hose, wiring issue to sensor, control board misinterpretation

Safety First: Unplug the washer and turn off water supply.

Step-by-step checks:

1. Locate analog pressure sensor: Usually a small rectangular or round module with a hose and electrical connector, mounted near the control board.
2. Inspect and clear hose: Remove the hose and blow through it to ensure it is clear. Clean the tub air dome port.
3. Check wiring: Ensure the connector is firmly seated and wires are intact.
4. Replace sensor: If F35 persists with a clear hose and good wiring, replace the analog pressure sensor with the correct Inglis part.

Medium 3/5

Analog Pressure Sensor

Check Price on Amazon

We may earn a commission from links on this page.